Manufacturer part #: Spyderline 4.8 mm
| Diameter | Weight | Tensile | ||
|---|---|---|---|---|
| Metric | lbs./100 ft. | g/m | American | Metric |
| 1.8 mm | 0.2 lb | 3.0 g | 350 lb | 159 kg |
| 2.8 mm | 0.4 lb | 6.0 g | 1,250 lb | 565 kg |
| 3.8 mm | 0.8 lb | 11.9 g | 1,860 lb | 845 kg |
| 4.8 mm | 1.3 lb | 19.3 g | 3,000 lb | 1,361 kg |
Manufacturer part #: Spyderline 4.8 mm
Spyderline is an ultra strong all-purpose dinghy control line. The twill pattern cover is made from 100% polyester and the core is 100% Dyneema SK 78 fiber. Very strong with extremely low stretch, Spyderline is perfect for use in small leads, micro blocks, and purchase systems. Sizes over 1.8mm have braided cores allowing for additional performance modifications.
Features
- Strong
- Very Lightweight
- Flexible yet firm enough to feed through micro blocks and purchase systems
- Sizes over 1.8mm have a spliceable core
Applications
- Cunninghams
- Vang Systems
- Outhauls
- Halyards
- Traveler Lines
- Trapeze Lines
- Topping Lifts
- Twings
Sunlight/Uv: Very little degradation from sunlight. Can be used outside over long term if inspected regularly.
Chemicals: Polyester has good resistance to most chemicals except 95% sulfuric acid and strong alkalines at boil. HMPE has good resistance to most minerals, organics, acids, and weak alkalines. HMPE also has excellent resistance to bleaches and other oxidizing agents and to most solvents.
Heat: Polyester melts at 480°F with progressive strength loss above 300°F. HMPE melts at 300°F with progressive strength loss above 150°F.
Dielectrics: Good resistance to the passage of electrical current. However, dirt, surface contaminants, water entrapment, and the like can significantly affect dielectric properties. Extreme caution should be exercised any time a rope is in the proximity of live circuits.
Sheaves: Recommended D/d * ratio is 8:1. (*Sheave diameter to rope diameter)
Working Loads: No blanket safe working load (SWL) recommendations can be made for any line because SWL's must be calculated based on application, conditions of use, and potential danger to personnel among other considerations. It is recommended that the end user establish working loads and safety factors based on best practices established by the end user's industry; by professional judgment and personal experience; and after thorough assessment of all risks.
The SWL is a guideline for the use of a rope in good condition for non-critical applications and should be reduced where life, limb, or valuable property is involved, or in cases of exceptional service such as shock loading, sustained loading, severe vibration, etc. The Cordage Institute specifies that the SWL of a rope shall be determined by dividing the Minimum Tensile Strength of the rope by a safety factor.
The safety factor ranges from 5 to 12 for non-critical uses and is typically set at 15 for life lines.
Manufacturer part #: Spyderline 4.8 mm
NER Core to Core Eye Splice.pdf
Call us for technical support, customer service and product information (877) 240-VELA (8352)